Report
Question
HI Do you have a video on how to replace the mortar in between the rocks, from the inside of the basement? Thanks, anna   Masonry is not a category below.

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
AnnaVamvakias 2 years 2 Answers 668 views
0

Report
Question
Just wanted your thoughts when doing 15-20 amp lines for lighting connections. Wire nuts vs Wago? I have used both, I find the wago a better choice for lights at switch or junction connections. Wanted to know what you think ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
solved 0
2 years 1 Answer 182 views
1

Report
Question
I am replacing a 20 amp breaker in the sub panel with a 30 amp, not a problem. I am running a #10 4wire for a dryer. The sub panel does NOT have a separate neutral bus bar. Where do ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Jprosie1
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
2 years 2 Answers 570 views
0

Report
Question
Hi Dominick I do not see a transformer, 220v coming from panel to sunstat, I noticed there was no light in front of the thermostat.   THX.

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Lucio 2 years 1 Answer 691 views
0

Report
Question
My bedroom ceiling has different angles, none of them are a defined edge. they are all slightly rounded. how do I create a straight line. I was going to measure eight feet from the floor, put points close together along ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
closed 0
2 years 1 Answer 171 views
1

Report
Question
If a 220 outlet is rated for 20 amp service. Does that mean the total amps of the outlet is divided by each leg of current or does it mean that each leg can handle 20 amps of current

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
solved 0
2 years 1 Answer 175 views
0

Report
Question
I’m swapping out my drop lights. When I cut the old one off I noticed it only had two wires...even though the reels power cord was a 3 pronged cord. The new light had a grounded cord also. Can I ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Larry 2 years 1 Answer 311 views
0

Report
Question
I asked you about replacing a GFCI breaker w/o pigtail, and you said standard replacement would be fine. I went back and I guess I didnt notice last time, (there is a pigtail), is it still ok to change to ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
solved 0
2 years 1 Answer 44 views
0