Question
What type of cement should I use for a custom shower pan install? i am installing it over plywood subfloor. I have watched your video multiple times but it doesn’t really explain the type of cement to use. Can you ...
in progress 0
Plumbing MikeHoch16 2 months 1 Answer 60 views

Question
I have a driveway drain that has the pipe at the top of the sewer type drain, it has been cleaned out before and I just want to know if I put a “u” on it like under a sink ...
in progress 0
Plumbing pinhead12 3 months 1 Answer 114 views

Question
Hey Dom! I found a nice amount of water damage under my sink and was able to isolate the problem to the hot water supply line, but it\\\’s up inside my pull down kitchen faucet. Do you think I could ...
in progress 0
Plumbing Nathan Crystal 4 months 1 Answer 113 views

Question
I recently replaced our pressure switch for our well. As of today, the well is cycling about every 10 minutes. I shut the water off, drained the system, and then checked the PSI in the pressure tank. The PSI was ...
in progress 0
Plumbing Rob Rob 5 months 1 Answer 165 views

Question
We have low pressure with our well. We have replaced the pressure switch and no change? The well is down about 160′ the pump is only 4 years old. Pressure tank is holding its pressure, Only thing left i guess ...
in progress 0
Plumbing acccab 6 months 11 Answers 245 views

Question
The bathtub faucet has separate hot and cold handles. The hot water will not completely shut off but keeps on drizzling. I tried replacing the rubber rings and pulling out the old stem and putting a completely new one in, ...
in progress 0
Plumbing dt 6 months 1 Answer 187 views

Question
Can not get water pressure above 30 psi replaced pressure switch. Switch is a 40-60 switch, tank pressure is at 36 psi . Have a submerge pump 3 wire
in progress 0
Plumbing Mark Bares 7 months 1 Answer 202 views

Question
Thanks for the videos! Would love to see a video about how to properly connect natural gas pipes as well as how to properly turn gas back on after turning it off at the meter. I need to cap a ...
in progress 0
Plumbing Kyle Heckman 8 months 2 Answers 245 views