Hello,

I am installing crown molding on my kitchen cabinets. However, I cannot proceed with my project, because I am having an incredible difficult time cutting the molding for the inside corners of my diagonal wall cabinet.  I bought a protractor and my angle reads at 45 degrees.  Therefore, I set my miter saw at 22.5 thinking this would work.  Well as you can imagine; it did not work.  The inside corners do not match up.

I was hoping you could provide me with some guidance on how to cut this particular angle.  Once i have this; I can move on with my project.

I attempted to load a picture, but it did not allow it.