Lovelady

Report
Question

Please briefly explain why you feel this question should be reported.

Report
Cancel

There is plenty of water pressure on the cold water side but when the handle is turned to the hot water side there is not much water pressure, also just drained the hot water tank and all the water was hot but water stays cool and the thermostat is set at 125 degrees. how could this problem be solved?

in progress 0
Gloster 2015-04-27T19:12:00-04:00 1 Answer 1240 views
0

Answer ( 1 )

  1. Dominick Amorosso
    0
    2015-04-27T19:48:53-04:00
    Report

    Please briefly explain why you feel this answer should be reported.

    Report
    Cancel

    There could be many things preventing this. On how many fixtures is this happening to?

    Your water heater may be clogged. One the top of the water heater where the hot and cold go into there is a fitting for each. These fittings can get clogged and more so if you have hard water. Not on all models. But you could check these but the lines will need to be removed.