Report
Question
What are the other plugs on the water heater? Which ones need to be removed? Which ones need something to be put in them? sincerely, searchwork

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
Can aluminum strap metal be used to support copper water pipe?

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
I use a combi boiler for heating and hot water. It seems that there is a small leak in the system, so I need to pressurize the system by opening and closing the valve on the "Filling loop" from time ...

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
Question said it all, can you install a crawl space fan under eve blowing in to attic for improved ventilation if you only have passive ventilation vents up top. Thank you.

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
My gas stove does not push all the way back against the wall because of this thing. I have a big black outlet behind my gas stove that has a tube like wire going in the bottom of the wall. There ...

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
Main panel, neutral and ground wires are on same bar. How to run neutral and ground to sub panel with separate buss bars. Also the ground bus bar in the sub panel is screwed right to the panel, does is ...

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
Dom, I am replacing 2 circuit breakers with 2 arc fault breakers. I followed your youtube video and understand what I need to do to install 1st breaker. I disconnect neutral wire from neutral bar and connect to breaker. I then ...

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
My daughter bedroom had no blow in insulation between the studs if the attic floor. For the winter I laid down unfaced fiberglass within the studs and then again across the top of the unfaced fiberglass insulation. My question is ...

Please briefly explain why you feel this question should be reported.

Report
Cancel

Report
Question
220v Dryer. 4 wire circuit, plug and wire to dryer terminals. 3 terminal strip (110, N, 110) plus chassis ground. There is no LOAD side wiring attached to the "N" terminal. Have found nothing disconnected that needs to attached to ...

Please briefly explain why you feel this question should be reported.

Report
Cancel