Report
Question
I bought a Harbor Freight 220 vdc/20 amp TIG welder recently. I have two 220 vdc/20 amp outlets in my shop, but the 3 three prongs on the shop receptacles will not accept the 220 vdc/20 amp plug on my ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
9 years 1 Answer 586 views
0

Report
Question
Hi - I'm trying to use a spring anchor to attach curtain rails to a plasterboard wall.  There is a huge amount of insulation in the wall, to the point that the spring won't open. Do I need a different type ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
karensco 10 years 1 Answer 585 views
0

Report
Question
Hi, I'm hoping you can help! I have a kitchen cupboard with two doors that have been put on wrong and they don't open! (see picture) I can't think of a solution, is there any way to find out the make / ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
James Smith 10 years 3 Answers 582 views
0

Report
Question
Trying to fit a blind above a kitchen window, Drill only goes in 1 cm before stopping Think a lintel may be in the way but have tried 2 cm and 8 cm above bottom of the top of the window, And ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
ray gaches 10 years 2 Answers 582 views
0

Report
Question
Hello! I am remodeling my bathroom and it was a complete tear out from walls to floor. I've had all the plumbing re-done (the house is 150 years old) and did not relocate any of them, just replaced them, although, there ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
10 years 1 Answer 582 views
0

Report
Question
My electric stovetop/oven is behind my gas fireplace which is in the "formal" living room. Why is not possible to fed into that gas line to allow me to have a gas stove?

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Bobbi 1 year 1 Answer 580 views
0

Report
Question
Please see photo - does anyone know a fix for this issue?  The fascia board extends and is not protected by the gutter so rain water runs down the exposed board.  Is there a cap for this?

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Woody Knouse 1 year 1 Answer 580 views
0

Report
Question
Dear Dominic, I would like to improve my outdoor walkway lighting, by adding motion detectors instead of a timer. I was considering replacing a 3-way light switch layout with motion detection sensors instead of the switch.  However, logic tells me that this ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Kevin Christofora 9 years 1 Answer 580 views
0