Report
Question
I want to add a 100 amp sub-panel from my main service panel. The main service panel that is attached to the meter box has two hot lugs and one ground buss bar. It does not have a neutral buss bar. How do ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Phil Arrants 10 years 3 Answers 721 views
0

Report
Question
Hi Dominick, The pictures below show what I found when I opened up a 3 way switch.  I want to install a dimmer on this switch, and I only see 2 red and one white wire coming from the box to connect ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Tom 10 years 1 Answer 1221 views
0

Report
Question
im getting ready to gut the inside of the house I am buying. We plan on removing the plaster and lathe walls in order to run hvac and better insulate the house. What is an easier and less messy way ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
CJ 10 years 1 Answer 658 views
0

Report
Question
Ok well let me start off my story by this. i went into the basement and noticed the floor was wet and the relief valve had popped off. so i initially thought it was time for a new one cause ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
STEPHEN DEROSA 10 years 6 Answers 1206 views
0

Report
Question
Hi Dominick, I am a DYIer with lots of experience/practice. Recently, due to budgetary constraints, I decided to learn how to "tune up" my heating system and hot water heater. There has been no problem with replacing the nozzles, cleaning the ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Joe Mastrosanti 10 years 7 Answers 1015 views
0

Report
Question
1. I am laying Ceramic tile in a 5X5 Entrance area.   Should I use Ready Mix thin set and grout? 2. While laying tile in a large area, do you continue to lay tile while working off of tile you just layed?

Please briefly explain why you feel this question should be reported.

Report
Cancel
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Dick Russell 10 years 2 Answers 719 views
0

Report
Question
hello to all, i converted my attached garage into a den, and now i'm wanting to add a extra sub panel on the exterior of my house for my rv hookups, i'm doing both 30 & 50 amp with more ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
0
Jacob 10 years 0 Answers 686 views
0

Report
Question
Hi Dominic, Just wanted to say I really learn a lot for your videos, so thanks. My question is, Do i need to put down a moisture underlayment or any underlayment when installing vinyl planks over a concrete subfloor? I ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Steven Bergstrom 10 years 1 Answer 641 views
0

Report
Question
We did an addition to my home in 2008. The ceiling in the bedroom has an apex. The paint is peeling at the apex where it was taped and painted.  The nails are corroding and paint is bubbling and falling down ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Jennifer 10 years 1 Answer 663 views
0

Report
Question
Hello, I am.  I was planning on s circuits a 15A and 20A. My plan was to use  gray PVC schedule 40 for electrical wire, UV or outside 14/2 for the 15A and 12/2 for the 20A pulled through the ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Frank 10 years 1 Answer 816 views
0