Report
Question
Dominick: Love what you do! Would you show America how to build Forms and everything involved in pouring a slab/sidewalk?   Thank you,   Lee

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Lee 9 years 3 Answers 906 views
0

Report
Question
Can I use the black tip from a pressure washer to spray my roof with shock. Do I have to water down my plants or cover them with plastic.

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
David j 9 years 1 Answer 974 views
0

Report
Question
HELLO, I AM INSTALLING SOME LOW VOLTAGE LIGHTING OUTDOORS ON MY DECK.  I AM USING A 300 WATT TRANSFORMER THAT SAYS IT CAN BE PLUGGED INTO ANY OUTLET TO POWER THE VARIOUS LIGHTS AROUND THE DECK.  I DO NOT HAVE A CONVIENENT PLUG ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
BRAD 9 years 1 Answer 1226 views
0

Report
Question
I have a building with a concrete floor that has commercial grade carpet on top.  I would like to put allure vinyl flooring over the carpet which would alleviate taking up the carpet that is glued down.  Is this recommended?

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
albert vanetten 9 years 1 Answer 981 views
0

Report
Question
I am installing a cook top above a cabinet. The cook top is rated 120/240 volt. I'll connect it to a new 40 amp circuit. I already watched your video for the circuit breaker installation... very good video. The cook top ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Jim Merhaut 9 years 1 Answer 1013 views
0

Report
Question
Hello, I am installing crown molding on my kitchen cabinets. However, I cannot proceed with my project, because I am having an incredible difficult time cutting the molding for the inside corners of my diagonal wall cabinet.  I bought a protractor and ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Julio Velazquez 9 years 1 Answer 1040 views
0

Report
Question
Finishing up my basement. How do I determine the size of the breaker in the main panel? I'm going to have (5) 15 amp breakers and (1) 20 amp breaker. I'm looking at approx. 3000 watts (rounded up), for the ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
thomas 9 years 1 Answer 1153 views
0

Report
Question
have main panel at power pole installed conduit to subpanel neutrals and ground rod at power pole are bonded just pulled 3 wires to sub panel is it permissable to install grd rod at sub panel seperate grd wires and neutrals ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
GLENN SMITH 9 years 1 Answer 889 views
0

Report
Question
I had two Watts 150a water arrestors installed by my washer a couple years back to prevent water hammer. The water hammer is back and I'm told I can "recharge" the arresters.  There is a bicycle-tire-like valve on the front ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
James Haven 9 years 1 Answer 1324 views
0

Report
Question
I have a European electric device with two prong plug.  I have a 220 volt 20 amp socket at my home.  I could not find an adaptor to plug the device to the socket.  Please advise.

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Anto 9 years 1 Answer 902 views
0

Report
Question
Need advice on how to install a plug (non-GFCI protected) in the garage for the beer fridge, while still keeping the GFCI outlet for future installation of outlets on the same wall in the garage. Have had the refrigerator plugged into ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
David 9 years 1 Answer 1347 views
1

Report
Question
I had a through the wall Trane AC/Heat pump(24 yrs old) plugged into a 5-20p wall receptacle. It died so I ordered an Amana AC/Heat pump. It will need to have a 6-20p wall receptacle. I know it's a 240V ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Tom Geoghegan 9 years 1 Answer 1067 views
0

Report
Question
My apartment has an "in-wall" permanent A/C.  The outlet is just below it and I am sure it is a 220V?  It is the only 220V outlet... It has only 1 plug.  I am looking for a remote control converter ...

Please briefly explain why you feel this question should be reported.

Report
Cancel
  1. Dominick Amorosso
    0
    Report

    Please briefly explain why you feel this answer should be reported.

    Report Cancel
in progress 0
Mary Ann Leader 9 years 5 Answers 1214 views
0