My Breaker box is Bryant there is 1 20amp breaker for old AC 110v New AC has a 220 plug I purchased new receptacle.. Which breaker type do I need to install? There are so many to chose from.
Please briefly explain why you feel this question should be reported.
Thanks for the videos. They're great. One thing, I tried to use your wire size calculator for sizing a 100 amp, 220 sub panel next to my main panel (6ft run) in copper. It told me 14awg, then 12awg for ...
Please briefly explain why you feel this question should be reported.
Hello,
My shop is 350' from my house and I have a 13 amp/110 volts air compressor and few lights. The compressor would be used periodically. Can you please tell me what size wire I would need?
Thank you
Please briefly explain why you feel this question should be reported.
Specifications:
Pump Voltage: AC 220V
Color: White
Material: Plastic
Size: 98*66*32cm/38.6"x26"x12.6"
I'm setting up a new hydroponic grow system in my shed and need to wire a new 220v plug and 110v plug. I have no electricity in my shed so I need help in ...
Please briefly explain why you feel this question should be reported.
I'm building a powder coat oven using using regular home stoves for my elements lights ect. I have a 220 welder in my garage(black-white-green wires) how do I connect the stove electronics wire(red-black-white-green wires) to my welder outlet? I've tried ...
Please briefly explain why you feel this question should be reported.
My shop is wired for 220V but I've never used anything other that 110V until this year. All my recepticals, including the new 220V, are metal surface mounts. All the 110V recepticals have the body of the device ...
Please briefly explain why you feel this question should be reported.
I was trying to plug a power tool to this receptacle but doesn’t work. Looks like 220v coming in which runs a well pump and 110v going to outside outlet. What type of receptacle do I need? Trying to plug ...
Please briefly explain why you feel this question should be reported.
I am putting a 50 amp panel in my garage. I ran 6/3 from the main panel in the house 50 feet to the 50 amp panel in the garage. My question is I only have 1 bus bar in ...
Please briefly explain why you feel this question should be reported.
I had installed a generator input on the side of the house(male 240 volt plug). I would like to build/add two 10 foot male plugs to a female 240 volt plug so ONE male is ONE phase and ...
Please briefly explain why you feel this question should be reported.
I have a 50amp RV plug, that I would like to use to power my shed, what would be the best way to use the 30-Foot 50 Amp Male Plug to Bare Wires to feed a small sub panel in ...
Please briefly explain why you feel this question should be reported.
I will install a long buried cable to a subpanel in a remote barn. Online wire-size calculators (including this one at AskMeDIY), require me to input if my circuit is 120 or 240 V, and this parameter produces ...
Please briefly explain why you feel this question should be reported.
I am adding electrical hot water heaters, 240 volt. Three heaters at 40 Amps each. And an electric car charger outlet, near future use. I suspect this will be too much for the current panel and am adding a sub ...
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Report Cancel